baltur BT 320 Guide Rapide page 98

6000-6999 Internal faults generated from within Up application-control (Fuel/air ratio control)
D1 D2
6000 ucSteuerArtEx
6001 ucBetrMoNr
6100 ucknr
6200 0
6201 0
6202 0
6203 0
6204 0
6205 Detected points No.
6206 Operating curve points index
6207 Original curve points index
6208 Original curve points index
6209 0
6210 0
6211 0
6212 Operating curve points index
6213 Original curve points index
6214 0
6215 0
6216 0
6217 Operating curve points index
6218 Original curve points index
6219 0
6220 Operating curve points index
6221 Original curve points index
6222 0
6223 0
6224 Error No.
6225 Status No.
6300 ucSMState
6400 ucknr
unknown Mode of Channel-Control
Overadressing of Array was detected
unknown Mode of Channel-Control
Avoid an endless loop
Avoid an endless loop
Avoid an endless loop
SSR.sS0.ucAkt SSR.sS0.uikanalenb changed without Aufrufkurve2Workram
No completely valid point found but curve not empty
number of points don't match Ram-curve (fatal error with task)
Writing firing-rate failed (Ram-error)
firing-rate point in original curve invalid
invalid point index
Point-approximation not possible, no prior point
Point-approximation not possible, no following point
Point-approximation failed, invalid according point
Writing setpoint failed (Ram-error)
invalid point-index
Point-approximation not possible, no prior point
Point-approximation not possible, no following point
Point-approximation failed, invalid according point
Return setpoint writing failed (Ram-error)
invalid point-index
Point-approximation failed, invalid according point
Evaluated-Correction-Setpoint-Writing failed (Ram-error)
invalid point-index
Writing failed: Ram-error
Writing failed: Ram-error
Too many differences between curves (sliding counter, substract 1 per cycle)
undefined state of statemachine
Detect undefined State of Statemachine
Division by 0
46 / 50
0006081511_201311
Description