baltur BT 320 Guide Rapide page 77

The display shows the "pilot burner in gas operation" menu
Fig. 5-34 pilot burner in gas operation menu
1 pilot burner in gas operation pictogram
2 activate the pilot burner in gas operation
3 accept setting by pressing enter.
i
Access level 2 is required to set this function!
accept or discard the entry!
Set pilot burner in oil operation
• Use the cursor keys
confirm this with enter
• change the ON/OFF functional state using the cursor keys
and confirm this bypressing enter
The display shows the "pilot burner in oil operation" menu.
Fig. 5-35 Pilot burner in oil operation menu
1 pilot burner in oil operation pictogram
2 activate pilot burner in oil operation
3 accept setting by pressing enter
i
Access level 2 is required to set this function!
accept or discard the entry!
Configuration of actuating outputs
• Use the cursor keys
confirm this with enter
The display shows the configuration of actuating outputs menu.
to select the menu and
.
.
to select the menu and
.
25 / 50
0006081511_201311
Fig. 5-36 configuration of actuating outputs menu
1 actuating drive position pictogram
2 Display channel 1, oil
3 Display channel 2, air
4 Display channel 3, off
5 Optional channel, off
curve setting of actuating drives
• Use the cursor keys
confirm this with enter
i
If you keep key pressed for more than 2 seconds in
the menue "Curve setting of actu-ating drives" you will cause
a fault shut-down.
The display shows the curve setting menu.
Fig. 5-37 curve setting menu
1 Ignition position firing-rate point
2 Set-point channel 1, oil
3 actual value channel 1, oil
4 Set-point channel 2, air
5 actual value channel 2, air
6 Set-point channel 3, oil
7 actual value channel 3, oil
8 curve data for this firing-rate point already exists
• Use the cursor keys
and confirm with enter
(displayed in reverse).
• Use the cursor keys
position.
• Use the cursor keys
• Use the cursor keys
the selected firing-rate point.
• Stellen Sie mit den cursor-Tasten die position des Stellan-
triebkanals im gewählten Last-punkt ein.
i
The actuators run to the adjusted position immediatelly after
adjusting it.
The fan motor mus run to adjust channel 4.
to select the menu and
.
to set the firing-rate point
Set-point channel 1 is chosen
to set the channel's actuator
to switch to the next channel.
to set actuator's position in