baltur BT 320 Guide Rapide page 96

2208
2209
2300
2301
2302
2303
2304
2305
2306
2307
2308
2309
2310
2350 -
2354
2400
2401
2500
2600
2601
2700
2800
2801
2802
2803
2804
2805
2806
2900
3000
3100
3101
3200
3201
3230
3250
3300
3301
3302
3303
3304
3305
4000-4999 Internal faults generated from within application (Fuel/air ratio control)
D1 D2
4000 0
4001 0
4100 sRampe.ucState
4200 ucVBMode
4302 0
4400 ucSteuerArtEx
Invalid Index for SQBLData15
Data request for data block, but no transmission.
Invalid state
Invalid state
Deleting curve, end of EI
Invalid state
Invalid state
Invalid parameter number (does not exist)
Invalid state (cold check)
Cold check
Cold check
Cold check
Invalid state
Cold check
Attempt to write to a modbus register
Modbus register described
Parameter with access level > 4
Does not find the operating mode
Transfer forbidden
Deleting curve, left EI
The air pressure was not droped but the burner still starts
It was opened more than one valve in the cold check
Maintenance mode on the main controller is active, but there is no mainte-
nance mode parameterized
Maintenance mode active but it is still ignite
Burner starts, while the supervisor controller is blocked
Burner starts, while no reference test was made
The stage sent by HP for the staged-operation does not seem plausible
Program load by the timer to high
All errors, for which no error number was registered
Error message of a password module
Error message of the password module
Internal overflow, intermediate result does not fit in the variable
Overflow of the end result
UP Version differs from HP version
Invalid parameter for staged burner-firing-rate controller
Sequence control BrennUm default case entered
Sequence control leakage test default case entered
Sequence control FAT default case
Sequence control post ventilation default case
Sequence control pre ventilation default case entered
Sequence control Ingnition default case entered
No curve point to the load of the ignition point
ucPIdx_R >= ucPunktAnzahl
invalid value of sRampe.ucState
invalid value of ucVBMode
No active air channel is defined (parameterization error)
invalid value of ucSteuerArtEx
44 / 50
0006081511_201311
Description