baltur BT 320 Guide Rapide page 60

Press EXIT again to quit main menu.
Press EXIT again to quit settings.
The burners runs now in automatic mode.
In case of troubles, the burner will go on lock-out mode and the
reason will be indicated on the display.
Check the lock code & press ENTER to unlock.
If the ignition setting is not good enough (e.g. too much air), the
burner cannot start. In that case adjust again the ignition point (see
page 3). otherwise make sure that no other reason may cause the
ignition failure.
8 / 50
0006081511_201311