baltur BT 320 Guide Rapide page 91

Fault Code
760 Fuel change during setting-mode is not allowed
763 Different curve selection on main processor and watchdog
processor
764 CO-controller - internal curve set failure
800 Parameter defective
801 Channel control mode is inconsistent between main processor and
watchdog processor (fatal error, no automatic restart possi-ble)
802 Integration of a channel into the fuel/air ratio control takes too
long (only one automatic restart possible)
803 Channel is locked for too long (fatal error, no automatic restart
possible)
804 Channel mode of the fuel/air ratio control does not match the type
of control (fatal error, no automatic restart possible)
805 Directly controlled channel runs to an invalid position, i.e. a
channel that is not deactivated nor controlled by fuel/air ratio
control
888 Fault interlocking active!
889 The gap between two remote fault releases is too short
990 Power failure
921 Output terminal for oil valve defective
922 Output terminal for ignition transformer defective
923 Output terminal for gas valve 1 defective
924 Output terminal for gas valve 2 defective
925 Output terminal for ignition transformer defective
928 Output terminal for oil pump defective
929 Output terminals for fan defective
986 Dynamic range test recognizes an invalid feedback
987 Change-over during staged operation takes too much time
985 VSM diagnosis error possible cause of error: BurnerTronic
expects a VSM module but the exchange of diagnosis data with
the module fails.
988 Fuel selection relay in the DFM is defective or inconsistent
feedback from DFM
989 Plausibility test of actuator feedback in programmed curve failed
990 Power failure
996 Secure parameter writing could not be finished. Device is blocked.
999 Internal Error! See chapter 4 Assignment of internal fault 999
D1
39 / 50
0006081511_201311
D2
Parameter No.
Channel
Channel
Channel
Channel
Channel + Date
Reference no.
Channel
Description