baltur BT 320 Guide Rapide page 71

confirm this with enter
The display shows the "Serial number" menu.
Fig. 5-11 Serial number menu
1 Serial number pictogram
2 User interface serial number
3 BurnerTronic serial number
5.4.6 p OSITIONS OF acTUaTING DrIveS
Display positions of actuating drives
• Use the cursor keys
confirm this with enter
The display shows the "actuating drives" menu.
Fig. 5-12 actuating drives menu
1 actuating drive pictogram
2 actuating drive channel 1 (oil)
3 actuating drive channel 2 (air)
4 actuating drive channel 3 (oil)
5 Optional channel OFF; control of frequency converter
6 actuatuing drive's actual position
i
The assignment of the channels is depending on the
configuration!
5.4.7 c Heck DIGITaL INpUTS/OUTpUTS
Check digital inputs
• Use the cursor keys
confirm this with enter
The display shows the "Digital inputs/outputs" menu.
.
to select the menu and
.
to select the menu and
.
19 / 50
0006081511_201311
1 2
Fig. 5-13 Digital inputs and outputs menu
1 Digital inputs pictogram [selected]
2 Digital outputs pictogram
• Select the menu and confirm this with enter
The display shows "Page 1 of inputs":
Fig. 5-14 Page 1 of inputs menu
1 Digital inputs pictogram
2 Jump to next page
3 Fuel selection oil [no]
4 Fuel selection gas [yes]
5 Burner start [yes] - terminal X10
i
The signals in points 3 and 4 in Fig. 5-14 Page 1 of inputs
menu are "logical" signals and not "physical". Background:
some signals may have more than one source (terminal,
LSB, field buses, parameters).
call up second page of inputs
• Use the cursor keys
confirm this with enter
The display shows "Page 2 of inputs":
Fig. 5-15 Page 2 of inputs menu
1 Digital inputs pictogram
2 Jump to next page
3 Oil pressure min present [no] - terminal X05
4 Gas pressure min present [yes] - terminal X05
5 air pressure min present [yes] - terminal X08
.
to select the next page and
.