baltur BT 320 Guide Rapide page 73

Fig. 5-20 page 3 digital outputs menu
1 Digital outputs pictogram
2 Jump to previous page
3 Jump to next page
4 Ignition valve [on] - terminal X03
5 Gas valve 1 [off] - terminal X01
6 Gas valve 2 [off] - terminal X02
call up fourth page of outputs
• Use the cursor keys
confirm this with enter
The display shows "Page 4 digital outputs" menu:
Fig. 5-21 page 4 digital outputs menu
1 Digital outputs pictogram
2 Jump to previous page
3 Oil pump [off] - terminal X26
4 Fuel selection oil [off] - terminal X24 (adjustable with p 809)
5 Fuel selection gas [off] - terminal X24 (adjustable with p
809)
to select the next page and
.
21 / 50
0006081511_201311
5.5MaNUaL MeNU paTH
MANUAL
Select the MANUAL path to carry out the following actions:
1 switching burner ON and OFF
2 burner firing-rate presetting
Display MaNUaL menu
• Use the cursor keys
confirm this with enter
The display shows the "Manual" menu.
Fig. 5-22 Menu manual
1 pictogram Manual
2 Start burner manually [off]
3 adjust burner firing-rate
4 pictogram confirm settings
The "Burner ON" control loop does not need to be switched on to
start the burner from this menu. The user interface assumes control
in this menu.If there is no contact with "Burner ON" signal from other
sources (terminal X10.2), the software switches off the burner when
you exit the menu.
If the burner is switched on manually via display, the BT300 no
!
longer responds to the "Burner ON" signal input at connector
X10.2. It is for this reason that limiters, monitors and other
sim-ilar safety functions must not be used with this input!
i
Leaving the window terminates burner operation!
adjust burner firing-rate
• Use the cursor keys
the burner firing-rate in % and confirm this selection with
enter .
• change the burner firing-rate with the cursor keys
and confirm this with enter
i
Please note, that you can adjust the burner firing-rate only
while burner is running.Start the burner before you adjust the
burner firing-rate as mentioned above.
5.6 SeTTINGS MeNU paTH
to select the path and
.
to select the adjustment of
.