Troubleshooting - SciCan E-STATIS Prep 40-P Manuel De L'opérateur

5 Troubleshooting

5 Troubleshooting
The medical device heats up and gets excessively hot when running without a load:
Check the amount of cooling air.
The medical device has no lighting:
Lighting control not activated - check symbol on the control box.
Phase interrupted (Error code "ERR 10"):
Check the connection.
Motor not correct connected (Error code "ERR 10"):
Check the connection.
Phase short circuit (Error code "ERR 84"):
Tube or motor defective. Repair needed.
Motor or attachment defects:
Incorrect pressure - Configure pressure in accordance with technical specifications.
Poor quality air or water supply - check symbol on the control box.
Note:
If necessary, insert a filter, water trap or air dryer.
Air requirements - see also: chapter 8 Specifications
Page 16
E-STATIS Prep 40-P