SciCan E-STATIS Prep 40-P Manuel De L'opérateur page 15

4 Operation
Pressing the "SPEAKER" button changes the operating status of the speaker
If the symbol is white, the speaker is on; if the symbol is light grey,
the speaker is off.
By pressing the "ILLUMINATION" symbol, a number appears next to the symbol.
This number can be changed using "+" or "–". The number 1 equals the lowest light
output, the number 9 is the maximum light output. Confirm the illumination
setting by pressing the "ILLUMINATION" symbol again. The set and stored value
appears next to the symbol.
By pressing the "FIBER OPTIC DELAY" symbol, the delay time can be changed using
"+" or "–" to choose from 1 second to 5 seconds (delay time). Confirm the fiber optic
delay time by pressing the "FIBER OPTIC DELAY" symbol again. The set and stored
value appears next to the symbol.
Pressing the "DISPLAY CONTRAST" button activates the symbol.
The display contrast can be changed using "+" or "–"
Confirm the contrast set by pressing the "DISPLAY CONTRAST" button again.
Select demo mode by pressing the "DEMO MODE" button.
The display changes to the P1 display.
The "START" button appears on the display.
Press "START" button - the motor starts running for 2 minutes max.
The running cycle of the motor can be interrupted by pressing "STOP" button.
By pressing the "RETURN" button the set-up menu appears and the demo
program is finished.
Press the "RETURN" button, and the main menu appears.
Stand-by time setting of the touch screen.
All manual settings could be reactivated to the factory settings by pressing
the "FACT SET" button.
Attention: All manual settings will be cancelled when this button is pressed.
Back to the main menu by pressing "RETURN" button.
Press one of the "ADDITIONAL MEMORY" buttons (button number 1 or
button number 2). With "+" or "–" select the desired transmission ratio.
Confirm the ratio by pressing the "ADDITIONAL MEMORY" button again
E-STATIS Prep 40-P
Page 15