Settings: Set-Up Menu - SciCan E-STATIS Prep 40-P Manuel De L'opérateur

4 Operation
Ratio / reduction rate
Direction of rotation (clockwise or counter-clockwise)
Light on / off
Speed selection at ratio 1:1
up to 1,000 rpm : in steps of 50
up to 2,000 rpm : in steps of 100
up to 10,000 rpm : in steps of 500
up to 40,000 rpm : in steps of 1,000
Menu P1, P2, P3, P4, P5, P6, P7, P8
Press the button P1, P2, ... or P8 (when activated, the button colour changes).
Activate the gear ratio by pressing the "GEAR RATIO" symbol.
Select the appropriate increase or reduction ratio using the "+" or "–" symbol.
Confirm the gear ratio by pressing the "GEAR RATIO" symbol again.
Activate the speed by pressing the "SPEED" symbol (when activated, the
background colour changes to light grey). Change the speed using the
"+" or "–" symbol until the speed you want appears in the display. Confirm
by pressing the "SPEED" symbol again. The colour changes to black.
Select the fiber optic light by pressing the "LIGHT" symbol. If the symbol is black,
the light is on; if the symbol is light grey, the light is off.
Select the direction of rotation by pressing the "DIRECTION OF ROTATION" symbol.
If the symbol is white, the direction of rotation is clockwise; if the symbol is light
grey, the direction of rotation is counter-clockwise.
Pressing the P1 button and holding it in until the signal sounds stores the options
set in menu option P1.
Follow the same procedure for setting P2, P3 ... or P8 if desired.

Settings: Set-up Menu

Press the "RETURN" button changes the display in set-up mode.
The following parameters can be set here:
Calibration (see: chapter 4 Installation and Commissioning "Calibrate foot control")
Speaker
Illumination
Fiber Optic Delay
Display contrast
Reverse time of Auto Reverse Forward
Page 14
Speed selection at ratio 4:1
up to 100 rpm : in steps of 5
up to 1,000 rpm : in steps of 50
up to 2,000 rpm : in steps of 100
up to 10,000 rpm : in steps of 500
Setting options
on / off
1 - 10
1 - 5 sec.
more / less
1 - 5 sec.
Factory setting
on
5
2
zero setting
2 sec.
E-STATIS Prep 40-P