Check/Lubricate Chain-Drive (Feed); Lubricate Height Adjustment (Thicknesser) - HOLZMANN MASCHINEN HOB 260ABS Mode D'emploi

NOTICE: DO NOT over-tension the belts to avoid damage to the bearings and excessive
heating.
Excessive belt tension leads to elongation, overheating and rapid belt wear.
The contamination of the belts with oil, grease, solvents, paint, etc. should be avoided.
Clean and dry the belts and the pulleys' ducts only with a soft brush or with a pure wool or paper
towel.
Do not use solvents or similar cleaning agents and never use water.

18.2.5 Check/lubricate Chain-drive (feed)

Check the chain for any damage (cracks, break-outs). The chain can be moved by turning the
friction wheel to view all parts. Lubricate chains with normal machine grease.

18.2.6 Lubricate height adjustment (thicknesser)

 Remove chips and dust from the machine.
Remove the belt/chain cover (loosen the screws and remove the cover).

Lower the thickness planing table completely.

Clean spindle/height adjustment unit and then grease with machine grease.

Move the thickness planing table 1x up and down to distribute the grease.

 Mount the cover again (hang in the cover and tighten the screws).
STORAGE
If stored incorrectly, important components can be damaged and destroyed. Store
packaged or already unpacked parts only under the intended environmental conditions.
Store the machine exclusively in a dry environment protected from external weather influences!
DISPOSAL
Observe national waste disposal regulations. Do not dispose of the machine,
machine components or operating materials in residual waste. If necessary,
contact your local authorities for information on available disposal options.
If you buy a new machine or an equivalent machine from your retailer, he is
obliged in certain countries to dispose of your old machine properly.
TROUBLESHOOTING
Danger due to electrical voltage! Handling the machine while it is connected to
the power source can result in serious injury or death. Disconnect the machine from
the power supply and secure it against unintentional reconnection before taking any
action to rectify the fault!
HOLZMANN MASCHINEN GmbH
 Replace the V-belt (shaft) (8) and reestablish the
www.holzmann-maschinen.at
correct belt tension as described in paragraph one
above.
NOTE
WARNING
STORAGE
55
HOB 260ABS