Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17.7.1 Planing of small workpieces
17.7.2 Planing of with tiltied planer fence
17.7.3 Planing of short workpieces
17.7.4 Surface planing of workpieces with a small cross section
HOLZMANN MASCHINEN GmbH
Wait until the shaft has come to a standstill before
www.holzmann-maschinen.at
carrying out any further work!
Lower the blade guard (3) so that the shaft is
covered.
Move the blade guard to the workpiece and fix it
with a distance of approx. 5mm.
When planing, place the workpiece with the
small side on the planer table and press with one
hand against the planer fence and planer table.
Push the workpiece slowly and evenly over the
shaft with the second hand.
Loosen the fixing lever of the planer fence (1).
Place the workpiece against the planer fence.
Adjust angle, fix planer fence.
Lower the blade guard (3) so that the shaft is
covered.
Adjust blade guard, 5mm distance to workpiece.
Switch on the machine.
When planing, place the workpiece with the
small side on the planer table and press with one
hand against the planer fence and planer table.
Push the workpiece slowly and evenly over the
shaft with the second hand.
When planing, workpieces with a small cross-
section, an additional wood angle must be fitted!
Adjust planer fence and blade guard to the size
of the sliding wood.
Place the workpiece on top and push it slowly
and evenly over the shaft using the sliding wood.
After use, the sliding wood must be reattached
on his place on the side of the machine.
When planing workpieces with a small cross-
section, an additional wood angle must be
mounted!
Fasten the wood angle to the planer fence as
shown using lever clamps.
When planing, place the workpiece on the planer
table and press it against the additional wood
angle and planer table.
Place the workpiece on top and push it slowly
and evenly over the shaft using the sliding wood.
OPERATION
48
HOB 260ABS
Publicité
Table des Matières
