Settings - HOLZMANN MASCHINEN HOB 260ABS Mode D'emploi

17.3 Settings

HOLZMANN MASCHINEN GmbH
1. Height adjustment of the planing tables
Entry planer table
The cutitting thickness is set with the adjusting screw
(1).
Back planer table
The height of the back planer table can be adjusted
with the adjusting screw (2).
2. Setting infeed / oufeed roller
The pressure force of the spring-mounted infeed and
outfeed roller is factory-set.
3. Setting arm and blade guard
4. Setting planer fence
The alignment of the planer fence at right angles
should be checked again before initial operation and
readjusted if necessary to achieve an exact planing
result.
NOTICE:
completely, the height can be adjusted with the four
screws (9).
www.holzmann-maschinen.at
 If it is necessary to change the pressure force, it
can be adjusted with the screws (3 and 4).
 The Allen key required for the adjustment can be
found in the toolbox, which is located at the rear
of the machine.
 The desired height of the blade guard is adjusted
with the adjusting screw (5) below the arm.
 After loosening the orange locking knob (6), the
blade guard can be moved moved in horizontal
direction and adapted to the size of the
workpiece.
 This orange locking knob is relocked when the
desired position is reached.
 The angle is measured with a protractor (7). This
is placed on the planer table and applied to the
planer fence.
 If it is not possible to place the protractor
completely against the planer fence, the planer
fence is not set exactly at right angles and an
adjustment is necessary.
 The angle is adjusted with the screw (8).
If the planer fence cannot be moved back
OPERATION
44
HOB 260ABS