Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
®
ABIPLAS
WELD
11 Dismounting
12 Disposal
12.1 Materials
Dismounting may only be carried out by specialized personnel. Please make
sure that the shutdown procedures are strictly observed before the dismounting
is started. Observe it also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the gas supply.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-15.
1 Disconnect the cable assembly from the power source.
2 Remove parts to be disconnected.
For the disposal observe the local regulations, laws, provisions, standards and
guidelines. For the product to be disposed of properly, it must be dismounted,
first.
See 11 Dismounting on page EN-19
This product is mainly made of metallic materials which can be melted in steel
and iron works and are, thus, almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
11 Dismounting
EN - 19
Publicité
Table des Matières
