Specifications; Staple Selection; Applications; Accessories - Hitachi N2503AF Mode D'emploi Et Consignes De Sécurité

SPECIFICATIONS

Operating Pressure
Actuation
Dimensions
Length x Height x Width
Weight
Staple Capacity
Air Consumption
Air Inlet

STAPLE SELECTION

WARNING
Be sure to use only the genuine HITACHI staples for the
•
N2503AF. The use of any other staples can result in tool
malfunction and/or staple breakdown, leading to serious
injuries.
Only Staples shown in the table below can be driven with this
Stapler.
20 GAUGE STAPLE
.188" (4.8mm)
.04" (.95mm)

APPLICATIONS

TONGUE AND GROOVE FLOORING
•
MOISTURE BARRIER
•
SUBFLOOR
•
Tongue and Groove
Flooring
Moisture
Barrier
Subfloor
The N2503AF Pneumatic Flooring Stapler, with the standard
shoe, drives 1" Staples into the tongue and groove flooring at a
45 degree angle. The orientation of the Staple is as depicted
above.
MIN. MAX
1" Staple
70-100 psi (4.8-6.9 bar 4.9-7.0 kgf/cm2)
Trigger operated - Sequential
10-1/8" x 9-5/8" x 2-5/16"
(257mm x 244mm x 59mm)
3.2 lbs (1.4 kg)
100 Staples
.026 ft3/cycle @ 80 psi
(.74 ltr/cycle @ 5.5 bar)
(.74 ltr/cycle @ 5.6 kgf/cm2)
1/4" NPT Thread
STAPLE APPLICATION CHART
STAPLE APPLICATION
1" STAPLE Angle fastener onto
5/8" - 3/4"
underlayment over
joist construction.

ACCESSORIES

WARNING
Accessories other than those shown below can lead to
•
malfunction and resulting injuries.

STANDARD ACCESSORIES

2. Safety Glasses
1. Carrying Case
1. Carry Case
NOTE: Accessories are subject to change without
any obligation on the part of HITACHI.

BEFORE OPERATION

Read over section titled "SAFETY" (pages 4 - 7)
Make sure of the following before operation.

WORKING ENVIRONMENT

WARNING
No flammable gas, liquid or other flammable objects at
•
worksite.
Clear the area of children or unauthorized
•
personnel.
9
English
T&G FLOORING
THICKNESS
1/4", 5/16", 3/8", 7/16"
3. Wrench Set