Facom BSYS.TKVAN Notice Originale page 28

EN
INSTRUCTIONS
Step 3 – Upper EcoFix Mounting
Parts (x24) Q
(self-tapping screw)
 Note: Set the electric screwdriver
to low speed and low torque, and
pay attention not to over-tighten the
fasteners.
5. Connect the top four EcoFix
fasteners to the van top beam. Use
at least 6 fasteners per fastener..
INSTRUCTIONS
Step 4 – Lower EcoFix Mounting
Parts (x24) Q
(self-tapping screw)
6. Connect the center four EcoFix
fasteners to the van center beam.
Use at-least 6 fasteners per
fastener.
INSTRUCTIONS
Step 5 – Completing the Install
Parts (x18) Q
(self-tapping screw))
(x2) F (cover cap)
1. Check and ensure the rack is
perpendicular to the van floor (do
NOT use a level).
2. Tighten the fasteners fastening all
the EcoFix fasteners to the rack
profiles.
3. Affix the remaining fasteners
connecting the rack feet to the
van floor. Use at least 10 fasteners
per foot.
10. Cover the support ends with cover
caps.
12
STEP 3
ACTION
STEP 4
ACTION
STEP 5
ACTION
END RESULT
END RESULT
END RESULT