Facom BSYS.TKVAN Notice Originale page 23

INSTRUCTIONS
Step 4 – Setting Profile Heights
Parts (x4) K (65 mm screw) )
(x4) J (nut)
(x4) M (small washer)
8. Set the height of the rack upper
profile:
 Note: The maximum height of the
rack must not exceed the height
marked on the package, and the
profiles must have a 200 mm (7
minimum overlap. See marking on
the top profile.
a. Place the rack foot on the van
floor, and raise the support
top profile until its upper edge
reaches the upper edge of the
van top beam.
Warning: Do not extend
beyond the 200 mm (7
STOP overlap marks.
b. Loosely connect the top profile
to the bottom profile.
3. Connect the top and bottom profiles
of the second support, and verify
both supports are the same height.
ACTION
/ ")
7
8
")
/
7
8
STEP 4
END RESULT
EN
7