Preparation And Vacuuming - Dirt Devil Trendino M680 Mode D'emploi

3 Preparation and Vacuuming

3.1 Unpacking
3 Preparation and Vacuuming
1. Unpack the appliance.
2. Check that it is undamaged and complete.
ATTENTION:
Always transport/send the appliance in its
original packaging so that it does not
become damaged. Keep the packing mate-
rial for this purpose.
Dispose of any packing material that is no
longer required in accordance with the pro-
visions applicable in your country.
NOTE:
If you should notice damage due to trans-
port, then contact your dealer immediately.
3.2 Preparation
WARNING:
Check the vacuum cleaner before each use.
A damaged appliance must never be used.
There is a risk of injury.
ATTENTION:
Only use the vacuum cleaner if the filter is
intact and dry, and inserted correctly. Make
sure that none of the openings are blocked.
Otherwise, the vacuum cleaner can become
damaged.
1. Unwind the electric cable from the cable
mount until you have reached the neces-
sary length.
2. Decide on one of the three ways of using
of your Trendino:
- as a stick vac for short-pile carpet, hard
floor, laminate flooring, tiles, etc.
Page 17, 'Use as a stick vac'
- as a brush vacuum cleaner by using
the switchable electric cleaning brush
for deep cleaning of carpets, runners,
etc. Brushing also straightens the carpet
pile.
Page 18, 'Use as a brush vacuum
cleaner'
- as a hand vac for mobile use, in partic-
ular in hard to reach places. With the
crevice nozzle (Fig. 1/15) pushed on,
the suction effect is additionally concen-
trated and makes vacuuming cracks
possible.
Page 18, 'Use as a hand vac'
3.3 Use as a stick vac
1. Put the telescopic stick into working posi-
tion by unlocking it (Fig. 2/A/1) and pulling
it out (Fig. 2/B). It clicks audibly into place.
2. Put the floor nozzle (Fig. 1/7) into vacuum-
ing position by folding it down.
3. Insert the plug into a plug socket.
ATTENTION:
Only operate the appliance if the electrical
voltage stated on the type plate matches the
voltage of your socket. Wrong voltage can
destroy the appliance.
4. Switch the appliance on by putting the 2-
stage switch (Fig. 1/4) into the centre.
5. To vacuum, push the vacuum cleaner
back and forth. When vacuuming, observe
the corresponding recommendations of
the flooring manufacturer.
17