Selecting Units Of Measurement; Countdown Timer - ADVANSEA DEPTH S400 Manuel Utilisateur

2.2.2. Selecting units of measurement

To change the unit of measurement for some data, press at least 2 seconds on the
or keys.
The following table summarizes the various units displayed according to the data
selected:
Data Unit of measurement
Battery voltage V
Depth Feet Metres
In bold, default units.

2.2.3. Countdown timer

Once CHRONO is displayed, trigger it by pressing simultaneously on the +
keys.
The countdown starts from the data displayed (which can be configured between 1
and 10 minutes, see menu paragraph 2.4.2.). A long beep signals when the
countdown switches to the full minute. The end of the countdown is signalled by a
short beep every second for the last 5 seconds followed by a long beep to mark the
end of the countdown.
When the countdown is finished, the countdown timer counts the navigation time in
hours/minutes (with two points flashing per second).
Press again simultaneously for at least 2 seconds on the + keys during the
countdown to stop it and reset the display to the selected value.
7
Installation and Operation Manual S400 series