Description Of Electrical Connections; Bus Connection; Sounder Connection; Connections - ADVANSEA DEPTH S400 Manuel Utilisateur

Drill a hole 50mm in diameter at the chosen location
Unscrew the nut located on the rear of the unit
Remove the adhesive protection around the unit
Insert and position the unit in the mounting hole
Screw back the nut

3.2.2 . Description of electrical connections

3.2.2.1. Bus connection

The bus link is provided by a 7-wire shielded cable, arranged as follows:
Red
Black
Orange
Yellow
White
Green
Blue

3.2.2.2. Sounder connection

Connection to the sounder sensor is via a 30 cm coaxial cable and an overmoulded
RCA connector.

3.2.3. Connections

Connect the sounder sensor to the RCA connector
Connect the - power to the black wire without connector and the red wire
to the + power via a switch and a 1A fuse.
For a system comprising several "Advansea" instruments, connect all the
orange bus wires from each instrument together.
Connect an NMEA source (GPS for example) to the yellow wire for the
+nmea and the black for the – nmea
See diagram below:
+12V DC
GND / NMEA (-) Input and Output
bus
NMEA input (+)
NMEA output (+)
Buzzer and external light
NC
Installation and Operation Manual S400 series
16