Setting The Battery Alarm Threshold; Configuration; Keel Offset - ADVANSEA DEPTH S400 Manuel Utilisateur

2.3.2. Setting the battery alarm threshold

The battery alarm allows you to monitor the supply voltage to your installation. This is
important, particularly for good sounder performance.
menu
Press , then once again on
adjust the required value of the threshold using the
Press to exit setup mode, or time out after 10 seconds.

2.4. Configuration

To identity the data that can be configured, the DEPTH unit will alternatively display
the data name and its current value (every 2 seconds). When changing the setting
value, the data will be fixed on the display.

2.4.1. Keel offset

The depth displayed on the DEPTH display represents the distance between the probe
mounted on the hull and the bottom, plus or minus the keel offset:
For a positive offset, the depth is measured from a point located above the
probe (Depth = distance between probe and bottom + Offset).
For a negative offset, the depth is measured from a point located below
the probe (Depth = distance between probe and bottom - Offset).
menu
to display the "bAt" low threshold page, then
2 seconds
Installation and Operation Manual S400 series
and keys.
10