Standby; Network Operation (Bus As-1) - ADVANSEA DEPTH S400 Manuel Utilisateur

menu
Press for 2 seconds, then
(on) or deactivate (OFF) the reset using the
Press to exit setup mode, or time out after 10 seconds.

2.5. Standby

To save energy on board, the "DEPTH" display can be placed on standby by pressing
for 5 seconds on the
Standby mode switches off backlighting, the screen, stops sensor measurement and
processing of NMEA input and output interfaces. Only the vital bus management and
keyboard functions remain active. Active displays present on the bus indicate
measurement impossible with an OFF icon instead of the data.
Standby mode is not saved. At any time, simply pressing one of the four keys or
cutting off the power stops standby mode and returns all device functions to
normal.

2.6. Network operation (Bus AS-1)

The AS-1 bus is used to connect products in the advanSea family via a rapid and
reliable exchange protocol. Only the bus wires need to be connected. No start-up
settings are required.
The communication protocol allows for multiple data exchange at previously defined
transmission speeds.
Thus, it is possible:
to exchange several similar measurements on the same bus, for example:
several sounder sources.
to change the units, the alarm threshold values or to calibrate from a
single instrument.
to activate or deactivate alarms from a single instrument.
The protocol allows exchange of similar data from different sources (direct
measurement from the sensor, or from the bus or via NMEA).
menu
until the "RSt" page is displayed, then activate
2 seconds
key.
Installation and Operation Manual S400 series
and keys.
13