Backlighting; Alarms - ADVANSEA DEPTH S400 Manuel Utilisateur

2.2.4. Backlighting

The display and the 4 keys are backlit, with 4 levels of intensity. Level "0" corresponds
to backlighting switched off.
To control backlighting:
Press the key to display the backlighting page, then the
and keys to adjust the lighting level from 0 to 4.
Pressing again on the
to control backlighting on other device displays.

2.3. Alarms

The icon is lit when at least one alarm has occurred on one item of data managed
by the DEPTH display. A sensor alarm appears when it is activated (different from 0)
and the measurement has exceeded the high or low threshold previously defined. This
alarm is then shown by:
The flashing icon
The data concerned by the alarm flashing,
Automatic lighting of the LCD backlighting to its highest level,
The internal buzzer sounds,
The buzzer or the external lights are activated.
An alarm can be cancelled and inhibited for 3 minutes by pressing on any key on the
keypad. After this period, a new alarm may be triggered when the measurement
sensor once again exceeds the programmed thresholds.
Several devices interconnected on the bus, can be used to relay a sensor alarm to
other compatible displays present on the network. Example: a depth alarm can be
viewed on all "DEPTH" displays present on board.
The Depth can be monitored by configuring high and low alarm thresholds.
The Battery voltage data can be monitored by configuring the low threshold alarm.
When selecting an alarm, the DEPTH unit will alternatively display the alarm name and
its current value (every 2 seconds). When changing the alarm value, the data will be
fixed on the display.
key send the lighting level on the bus
Installation and Operation Manual S400 series
8