Resetting The Max. Wind Speed To Zero; Measurement Units - ADVANSEA WIND S400 Manuel Utilisateur

2.2.3. Resetting the MAX wind speed
To reset the maximum apparent wind speed, display the data on the lower display
and press and

2.2.4. Measurement units

It is possible to choose from several measurement units to display apparent wind
speed, max. apparent wind speed, true wind speed and VMG. The table below
summarizes the various units displayed:
Data
Apparent wind speed
Max. apparent wind speed
True wind speed
Max. true wind speed
VMG
To change a unit of measurement:
On the lower display, select the information whose unit of measurement you want to
change, and press
The units for "apparent wind angle" and true wind angle" are always displayed in
degrees, and the battery voltage is always displayed in volts.
2.2.5. Setting the backlighting
The display and the 4 keys are backlit, with 4 levels of intensity. Level "0"
corresponds to backlighting switched off.
To control backlighting:
Press to display the backlighting page, then press
to set the backlighting level from 0 to 4.
Pressing again on the
bus to control backlighting on other device displays, or
automatic time out after 10 seconds for local setting.
simultaneously for 2 seconds.
Knots
Knots
for 2 seconds.
key sends the lighting level on the
Installation and Operation Manual S400 series
Unit of measurement
m/s Miles/h
km/h
Beaufort
Miles/h
9