Key Beeps; Resetting Data In The Memory - ADVANSEA SPEED S400 Manuel Utilisateur

Press to exit setup mode, or time out after 10 seconds.

2.4.7. Key beeps

The key beeps can be activated or deactivated.
menu
Press for 2 seconds, then
(on) or deactivate (OFF) the beep using the
Press to exit setup mode, or time out after 10 seconds.

2.4.8. Resetting data in the memory

At any time, the memory of the Multi display can be returned to factory settings. To do
so, a memory reset command is accessible in the menu. The following parameters are
restored in the memory:
Speed unit:
Distance unit:
Temperature unit:
Speed damping:
Speed calibration coeff.:
Temp. calibration coeff.:
Temperature alarms:
Battery alarm:
Countdown timer init.:
2 seconds
menu
until the "bIP" page is displayed, then activate
2 seconds
Knots
Nautical Miles
°Celsius
10 seconds
Slope at 1.0
Offset to 0
deactivated, high and low threshold at 0
deactivated, low threshold at 0
10 minutes
Installation and Operation Manual S400 series
and keys.
15