Setting The Speed Alarm Thresholds - ADVANSEA SPEED S400 Manuel Utilisateur

The internal buzzer sounds,
The buzzer or the external lights are activated.
An alarm can be cancelled and inhibited for 3 minutes by pressing on any key on the
keypad. After this period, a new alarm may be triggered when the measurement
sensor once again exceeds the programmed thresholds.
Several devices interconnected on the bus, can be used to relay a sensor alarm to
other compatible displays present on the network. Example: a boat speed alarm can
be viewed on all "SPEED" displays present on board.
The Boat speed data can be monitored by configuring high and low alarm thresholds.
The Battery voltage data can be monitored by configuring the low threshold alarm.
When selecting an alarm, the SPEED unit will alternatively display the alarm name and
its current value (every 2 seconds). When changing the alarm value, the data will be
fixed on the display.

2.3.1. Setting the speed alarm thresholds

High speed alarm setting:
menu
Press , then once again on
for the speedo, then adjust the required value of the threshold using the
keys.
Press to exit setup mode, or time out after 10 seconds.
Low speed alarm setting:
menu
to display the "SPEED HI" high threshold page
2 seconds
Installation and Operation Manual S400 series
and
10