Calibrating By Log - ADVANSEA SPEED S400 Manuel Utilisateur

The boat speed is calibrated in the calibration menu, by replacing the boat speed
displayed with the boat speed estimated by the user, or measured using another
source.
We recommend you navigate at constant speed. Note the speed displayed on a GPS
receiver (it should be greater than 5 kts) or measure the time taken to cover a given
distance (speed between 5 and 20 kts, in calm seas, with little current).
menu
Press for 2 seconds, then on
adjust the required value using the
Press to exit setup mode, or time out after 10 seconds.

2.4.4. Calibrating by log

After resetting the Trip log to "0", cover a specific set distance (identified on a chart).
To partly compensate for current and tide effects, cover the distance in both
directions, parallel to the current.
In the calibration menu, replace the distance displayed for the Trip log with the real
distance covered.
menu
Press for 2 seconds, then on
adjust the required value using the
the value measured by the Trip log).
Press to exit setup mode, or time out after 10 seconds.
menu
until the " SPd" setup page is displayed, then
and
2 seconds
menu
until the "LOG" setup page is displayed, then
and
2 seconds
Installation and Operation Manual S400 series
keys.
keys (max. ±50% adjustment of
13