ADVANSEA SPEED S400 Manuel Utilisateur page 23

4. Troubleshooting
This troubleshooting guide assumes that you have read and understood this manual.
It is possible in many cases to solve difficulties without the need for the after-sales
service. Please read this chapter carefully before contacting your AdvanSea retailer.
1. The unit will not power on:
2. Wrong or incoherent speed reading:
3. Wrong temperature reading:
4. SIMU flashing on the screen, with incoherent readings displayed.
If the problems continue, we recommend you contact your advanSea retailer or our
customer support department. All contacts can be found at www.advansea.com.
Fuse melted or circuit breaker triggered.
Voltage too low
Power cable disconnected or damaged.
Calibration incorrect
Speed sensor cable disconnected or damaged
Speed/temperature sensor damaged. Check the paddlewheel.
Incorrect mounting or sensor not sufficiently immersed.
Review the installation.
Electrical interference. Review the installation.
Calibration incorrect.
Speed/temperature sensor cable damaged.
Unit in simulation mode.
Installation and Operation Manual S400 series
22