Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To calibrate the wind angle:
menu
Press
for 2 seconds, then again on
page "diR" is displayed, and adjust the value using the
Press
to exit setup mode, or automatic timeout after 10 seconds.
2.4.4. Selecting the pointer
1 of the 4 available pointers can be selected to display the apparent wind angle in
analogue form.
To set the pointer:
Press for 2 seconds on
displayed, then adjust the required value using the
Press
to exit setup mode, or automatic timeout after 10 seconds.
2.4.5. Simulation mode
Simulation mode is used to display coherent data which are simulated and not
measured by the sensors. When this mode is in operation, a
flashing at the bottom of the display.
In simulation mode, the following data are available:
An apparent wind speed and angle,
A true wind speed and angle,
the real supply voltage,
Transmission of simulated data via the NMEA output,
Transmission of simulated data via the communication bus.
menu
menu
, then on
Installation and Operation Manual S400 series
menu
until the wind indicator calibration
and
until the pointer setup page "Ptr" is
and
keys.
keys.
icon appears
12
Publicité
Chapitres
Table des Matières
