Use Of The Picking Machine; Important - Volpi OLYTECH mondial 755SP Manuel D'utilisation Et De Maintenance

Codes 865SP-L-XL Ref. fig. C.4
Link the connector positioned at the bottom of the pole -D- to the connector -E- positioned at the end of
the extension cable -S- and screw it.
Insert the other connector -F- of the cable S into the socket J of the battery H.
Switch on the battery with the W switch.
The battery must never be connected to the charger while used.
Press the button Z on the handle to switch the machine ON. The red led on the handle lights up and
stays on until the machines is turned off.
The machine has three different working speeds, selectable using the X button (to increase speed) and L
button (to reduce the speed), positioned on the handle.
At first switching on, the machine will start at speed 1 (the lowest), then changeable as described above.
If the machine is switched off without disconnecting the battery, next time you switch it on it will start at
the last selected speed.
If the battery is disconnected, next time you switch the machine on, it will start at speed 1 (lowest).
Press the button Z on the handle in order to switch the machine off.
Volpi Lithium battery characteristics: nominal voltage 44V – Capacity 17,5Ah.
Outside temperature between +1°C and +40°C.
5.

USE OF THE PICKING MACHINE

Codes 755SP-L-XL
The machine power supply is provided by a lead acid accumulator – 12V battery - 70÷80Ah (not
included) that, through a 15m long power cable with clamps for the connection to the battery, can give
power directly to the motor of the machine. Since there is no adjustment of the supply voltage, the motor
rotation speed is maximum when the battery is charged, and decreases slightly while the battery is
discharging. This situation is normal. When the tines rotating speed reduces intensely, you have to switch
off the machine and charge the battery.
In case of overloading, with excessive effort of the head among the branches, the motor stops
automatically in order to protect all the parts of the machine. In such case, remove the head from the
branches and after 1 second the machine restarts automatically.
After 5 consecutive times of locking of the head between the branches, with overloading, the machine
does not restart automatically and the red led fleshes. In such case, after having removed the head from
the branches, it is necessary to restart the machine with button Z.
If such a security system activates frequently, it means that the impact of the machine with the tree
branches is too violent and, therefore, it is necessary to use the harvester with more regularity.
If the machine does not start and the led on the handle flashes, it means that the battery output voltage
is below the minimum and so the battery must be recharged.
IMPORTANT: in the majority of cases, speed 1 is enough for olive harvesting so it is recommended. In
the few cases where more harvesting energy is temporarily needed, you can use speed 2 or 3. The use
of speed 1 allows a high energy saving and a longer battery operating time.
Do not connect the battery to the machine when it is not used.
Codes 845SP-L-XL
Energy to the machine is provided by a 12-24Vdc-50÷60Ah car type battery (not included) connected to
the electronic converter by 1mt two wires cable holding two nippers, red on the positive (+) and black on
the negative (-).
The circuit converts the supply voltage from 12V to 44V.
Davide e Luigi Volpi S.p.A.
COMPANY WITH QUALITY SYSTEM
40
Via San Rocco, 10 – 46040 Casalromano (MN) – Italia
MANAGEMENT CERTIFIED BY ICIM
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
= ISO 9001 =