Transport And Handling Instructions; Instructions For Use - Volpi V BLACK ELEKTRON Mode D'emploi

4.

TRANSPORT AND HANDLING INSTRUCTIONS

The transport of the sprayer must be realized using all the necessary cautions in order to avoid damages.
When transporting the sprayer please make sure the switch on/off is always off.
During transport, the tank must always be empty or, if not possible, safely fixed in order to avoid accidental outpours of liquid.
During transport and storing, do not put the sprayer on or under other material.
When moving the sprayer, it is recommended to avoid bumps, which could damage the product.
5.

INSTRUCTIONS FOR USE

5.1. SETTING OF THE SPRAYER
- Unscrew the nut 10B from the handle 10A.
- Put the nut 10B on the delivery hose 9.
- Put the delivery hose 9 into the hose holder positioned on the handle.
- Screw the nut 10B on the handle 10A.
- Screw the extension 12 on the handle 10A
WARNING: when screwing the extension, pay attention to properly couple the threads.
- Fit the shoulder belts P (Fig. "A") as shown in the picture below
Adjust the shoulder belts P (Fig. "A")
-
Switch on the sprayer through the switch A (Fig. "A") and check the charging status on the voltmeter C (Fig. "A");
-
then, switch off immediately the sprayer. If the battery is empty, recharge it by following the instructions reported in
paragraph 6.2.
5.2. FILLING OF THE TANK
Prepare the solution in a specific container.
Unscrew the cap of the tank and pour the prepared solution through the filter.
Carefully screw the cap.
DAVIDE E LUIGI VOLPI S.p.A. - Via San Rocco,10 - 46040 CASALROMANO (MN) - ITALY
Davide e Luigi Volpi S.p.A.
Via San Rocco,10 – 46040 Casalromano (MN) – Italy
Tel. +39 0376.76009 - 76012 Fax. +39 0376.76408
www.volpioriginale.it
E-mail: commerciale@volpioriginale.it – export@volpioriginale.it
YLB19VBE_2 Libretto d'uso V_BLACK ELEKTRON
pag. 14 di 48