Safety Instructions; Important Notice; Residual Risks - Volpi OLYTECH mondial 755SP Manuel D'utilisation Et De Maintenance

9.

SAFETY INSTRUCTIONS

755SP-L-XL 845SP-L-XL 855SP-L-XL 865SP-L-XL
Codes
PERSONAL SAFETY
• For safety reasons, kids, young people below 16 years old and whoever is not familiar with the
"Operation and Maintenance Manual" cannot use the machine.
• Each time you need to clear or repair the machine, be sure that the electrical circuit is disconnected.
• Do not use the machine under rain.
• Do not use next to electrical cables at high tension.
• It may happen that some parts become hot during the usage. Don't touch.
• Do not switch on the machine while charging the battery.

IMPORTANT NOTICE

Operations not allowed:
•
All modification to the machine are not allowed except it authorized by the manufacturer.
• Use of not original spare parts is not permitted. In case of utilization of not original parts all forms of
warranty will end.
•
During the operation of the machine it is advisable to use protective glasses.
• After using the machine it is advisable to clean the engine area from dust and scraps and then put it
in a dry and clear zone, with batteries fully charged and disconnected.
VIBRATIONS AND NOISE
• Weighted root mean square acceleration value to which the hand/arm system is subjected is 7 m/ s
(maximum value).
• Equivalent continuous A - weighted sound pressure level=81 dB(A).
• Maximum value of the C - weighted instantaneous sound pressure Lpc<130 dB(C).
SAFETY SIGNALS (Pictograms)
The most important indications about the correct and safe use of the harvester are shown by symbols
(pictograms) on the machine, that must be kept intact, clean and readable.
The meaning of each symbol is reported in fig. H.
INCORRECT USE
• Do not direct the machine towards people or animals
• Do not use the machine directly over the body (over your head), to avoid the falling fruits hit you
• Do not use the machine on non-recommended plants

RESIDUAL RISKS

• Due to the fast movement of the tines, there is a crush risk for the hands/fingers. This risk is very
low; but it cannot be reduced, since it is inherent to the working cycle. We recommend not
touching the tines while they are moving and not direct them towards people or animals.
• Eventual residual risks could be caused by the incorrect use, such as for example by using the
machine for a very long time without having a break. This could generate problems to the arms of
the operator. We recommend a careful evaluation concerning the working hours.
COMPANY WITH QUALITY SYSTEM
MANAGEMENT CERTIFIED BY ICIM
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
= ISO 9001 =
Davide e Luigi Volpi S.p.A.
Via San Rocco, 10 – 46040 Casalromano (MN) – Italia
2
44