Maintenance And Cleaning - Beurer ELLE MPE 58 Mode D'emploi

4. Operation
Drying UV nail gel
1. Insert the mains plug into the socket.
2. Press the ON/OFF button to switch on the device.
3. Using the UV light button, select your desired UV light treatment time.
You can choose between three different UV light treatment times (90 second timer, 120 second timer and
continuous operation).
Once the set treatment time has passed, the UV light switches off automatically (except in continuous
operation).
4. Insert your nails varnished with UV nail gel into the opening in the device (with your nails facing upwards).
5. Switch the device off after use. To do this press the ON/OFF button and pull the mains plug out of the
socket.
Drying varnished nails
1. Insert the mains plug into the socket.
2. Press the ON/OFF button to switch on the device.
3. To switch on the dryer function, press the dryer button.
The fan inside the housing will begin to rotate.
4. Insert your your nails varnished with nail varnish into the opening in the device (with your nails facing up-
wards).
5. As soon as your nail varnish has dried, switch the device off. To do this press the ON/OFF button and pull
the mains plug out of the socket.

5. Maintenance and cleaning

Replacing the fluorescent tubes
If one of the four fluorescent tubes ceases to work properly, replace all four fluorescent tubes.
You can order the required fluorescent tubes from Customer Services.
Warning
Before replacing the fluorescent tubes, pull the mains plug out of the socket!
Important
Only insert UV-9W-L type fluorescent tubes into the device.
To replace the fluorescent tubes, follow the steps contained in section "3. Initial use".
Cleaning
Warning
Before beginning cleaning, pull the mains plug out of the socket!
• Clean the base plate after each use.
• Clean the surface of the device and the base plate carefully using a slightly damp cloth only.
• Do not use any cleaning agents or solvents.
11