DeWalt DWE46102 Guide D'utilisation page 12

6" (150 mm) Cutting Wheels
Type 1 guard
backing flange
abrasive cutting wheel diamond cutting wheel
clamp nut
Mounting Guard
MOUNTING AND REMOVING GUARD (FIG. 4, 5)
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding
with conventional sanding discs. A Type 27 guard (intended for
use with depressed center grinding wheels [Type 27 and Type
29], sanding flap discs, wire wheels and wire cup brushes) is
available at extra cost from your local dealer or authorized service
Sanding Discs
rubber backing pad
Type 1 guard
sanding disc
backing flange
threaded clamp nut
clamp nut
6" (150 mm) Sanding Flap Discs
Type 27 guard
hubbed sanding
flap disc
center. Grinding and cutting with wheels other than Type 27 and
29 require different accessory guards not included with tool. A
Type 1 guard is provided for use with the Type 1 wheel. Mounting
instructions for accessory guards are shown below and are also
included in the accessory package.
10
Type 27 guard
backing flange
non-hubbed sanding
flap disc
threaded clamp nut