Publicité
Les langues disponibles
Les langues disponibles
6" (150 mm) Grinding Wheels
Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Rotating the Gear Case (FIg. 3)
1. Remove the four corner screws attaching
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/8"
(3.17 mm), the tool must be serviced and re-assembled by a D
service center. Failure to have the tool serviced may cause brush,
motor and bearing failure.
Type 27 guard
Type 27 hubbed wheel
Accessories
It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See pages 9–10 for information on
choosing the correct accessories.
FIG. 3
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Threaded accessories must have a 5/8"–11 hub. Every
unthreaded accessory must have a 7/8" arbor hole. If it does not, it
may have been designed for a circular saw and should not be used.
90˚
90˚
Use only the accessories shown on pages 9–10 of this manual.
Accessory ratings must be above listed minimum wheel speed as
WALT
E
shown on tool nameplate.
9
Wire Wheels
Type 27 guard
3" wire cup
brush
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 20 in.-lbs. torque. Overtightening could cause
screws to strip.
WARNING: Accessories must be rated for at least the speed
Type 27 guard
4" wire wheel
Publicité
