Delta Q MINIQOOL Manuel D'instructions page 46

AFTER A LONG PERIOD OF NON-USE
PREPARATION
Remove the water tank and fill it with water.
1
Remove the water tank and the lid.
Rinse the water tank before using.
Fill the water tank to the MAX level shown with cold
drinking water only.
Reattach the lid and reinsert the water tank correctly.
The water level should never be higher than the MAX level
or lower than the MIN level.
Turn the device on.
2
Plug the lead into the socket.
Turn the device on by pressing any of the
buttons
Pre-heating:
A white light will illuminate the Delta Q logo;
The buttons will blink in sequence (green colour) for about 1 minute.
Ready to use:
After reaching the right temperature, buttons A, B and C will turn green.
Place a cup (min. 180 cc) under the nozzle
3
Press the Long drinks button to rinse the device
4
Repeat this step twice.
If water does not come out, remove the water tank and re-insert it in its original position.
Repeat this step until there is a continuous flow of water.
.
— 44 —
EN
A B C
C