Publicité
Les langues disponibles
Les langues disponibles
STANDBY/ PROGRAMMING THE VOLUME
STANDBY
If the machine is not used for 3 minutes, the lights
on buttons A, B and C will go out.
Press any button (A, B or C) to return to the ready to use mode.
The machine will automatically heat up the system.
Removing the drip tray will not wake the device up.
PROGRAMMING THE VOLUME
Programming the espresso extraction button
When in ready to use mode, press button A for more
than 3 seconds.
Button A will light up green and buttons B and C will start
to flash green.
Insert a Delta Q capsule into the capsule holder.
Press button A to start the espresso extraction process.
The button A will start to flash.
Press button A again to stop the extraction process.
The machine will memorise the volume extracted.
Button A will then extract this new volume.
After extraction, the machine will return to ready to use mode.
If no button is pressed for 1 minute, the machine will return to ready to use mode and
will memorise the last volume set.
If button A is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 75cc.
Programming the lungo extraction button
The steps are the same as for predefining an espresso.
Press button B instead of button A.
If button B is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 75cc.
Programming the Long drinks extraction button
The steps are the same as for predefining an espresso.
Press button C instead of button A.
If button C is not pressed to stop the extraction process, the machine will automatically
If button C is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 200cc.
stop when it reaches approximately 200cc.
— 42 —
EN
A
C
B
A
B
C
A
B
C
Publicité
