Delta Q MINIQOOL Manuel D'instructions page 42

FIRST USE
The First Use procedure is performed only once.
The machine might make a loud noise because the water circuit is empty.
NOTE: DO NOT INSERT A CAPSULE.
Remove the water tank and fill it with water.
1
Remove the water tank and the lid.
Rinse the water tank before using.
Fill the water tank to the MAX level shown with cold drinking water only.
Reattach the lid and reinsert the water tank correctly.
The water level should never be higher than the MAX level or lower
than the MIN level.
Turn the machine on.
2
Plug the lead into the socket. Press the Espresso button.
The Espresso button will go steady green. The other buttons will remain off.
Place a container (with a capacity over 180 cc) on the cup
support.
Press the Espresso button.
The machine will start the cleaning procedure. The cleaning
procedure may take up to 3 minutes. The Espresso button will
flash green.
Once the cleaning procedure is complete, the Espresso button will go off.
The three extraction buttons will remain off.
Heating up
3
Press any extraction button to start heating up the machine.
A white light will illuminate the Delta Q logo;
The extraction buttons will flash for about 1 minute.
Ready to use:
After reaching the right temperature, buttons A, B and C will turn green.
If no water comes out of the machine, please repeat the First Use procedure up to step 2.
If no water comes out on the second try, please contact our Customer Service Line.
— 40 —
EN
C
A
B