Publicité
Les langues disponibles
Les langues disponibles
Problem
There are white stains on the dishes.
The dishes are not dry.
There are rust stains on the dishes.
Possible cause
The selected program is not suitable
for the loaded dishes.
One of the spray arms is clogged.
The filters are clogged.
The filters are not placed correctly.
The water drain pump is clogged.
The amount of detergent is
insufficient.
The level of rinse aid consumption is
set too low.
There is a high level of water
hardness and no salt is used.
The level of water hardness is
set too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
The level of salt consumption is set
too high.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of
the salt reservoir was not cleaned
immediately.
The water supply is polluted.
Possible solution
Choose a suitable program. Refer to
Programs
section
.
Clean the spray arms. Refer to
Cleaning the spray arms
section
Clean the filters. Refer to section
Cleaning the filters
.
Make sure that you correctly place
the filters.
Make sure that the water drain pump
is not clogged.
Make sure that you fill the detergent
reservoir with a sufficient amount of
detergent. Refer to section
detergent reservoir
.
Adjust the level of rinse aid
consumption. Refer to section
Setting the level of rinse aid
consumption
.
Fill the salt reservoir. Refer to
Filling the salt reservoir
section
Adjust the level of salt consumption.
Refer to section
Setting the level of
salt consumption
.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
Programs
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
Setting the level of rinse aid
consumption
.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
Refer to section
Setting the level of
salt consumption
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Do a check on the water supply.
English
.
Filling the
.
.
•
47
Publicité
