Elcometer Sagola MINI XTREME MIX Manuel D'utilisation page 33

14. Lubrication
The original lubrication of the gun is eliminated through
use and cleaning. In order to guarantee perfect operation,
it is necessary to grease the regulating or fastening
threads, friction areas, etc., on a periodic basis, especially
after each cleaning session and with greater care if the gun
has been cleaned in a machine. Moving parts must be
lubricated lightly after cleaning has been completed.
We recommend you to use a light SAE 10 oil or natural
grease or vasoline.
It is important to check that the lubricant used does not
contain components that might impair the spraying
quality (Silicones, etc.).
15. Health and Safety
In order to carry out maintenance, repairs or cleaning, first
disconnect the unit from the compressed air distribution network
and feeding of product.and always tighten the lock* (clockwise) until
the needle does not move due to the action of the trigger.
* Safety system incorporated in later versions dated 2019/04
• Safe disconnection from the product hose:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding container.
Depressurise the product hose properly and, using a spanner, unscrew the end of the hose from the
product inlet connector, holding the pistol firmly.
• Safe connection from the product hose:
Connect the hose to the pistol. Hold the pistol firmly and, using a spanner, screw the end of the hose
into the air inlet connector. Check there are no leaks.
• Safe disconnection from the compressed air network:
If there is any cleaning liquid or product remaining, return it to its corresponding container. If the
pneumatic connector is fitted in the air inlet, disconnect the hose from the pistol. If it is not, depressurise
the air hose properly and, using a spanner, unscrew the end of the hose from the air inlet connector,
holding the pistol firmly, and if it is with fast connection click on the racord and remove the hose.
• Safe connection to the compressed air network:
If the pneumatic connector is fitted in the air inlet, connect the hose to the pistol. If it is not, hold the
pistol firmly and, using a spanner, screw the end of the hose into the air inlet connector or if it is with fast
connection, insert the hose into the hole. Check there are no leaks.
Never point the unit towards yourself, others or animals. The thinners and dilution
media used can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at that
time. After work has been completed, thinners and the product to be applied must be returned to their
corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
www.sagola.com
an Elcometer company
EN 33