Publicité
Les langues disponibles
Les langues disponibles
Pay special attention to the application speed. The thickness of the film deposited may be greater
than planned if the application speed is low, and the opposite is also true.
If the thickness of the layer is very thin, this is due to the fact that the air pressure is excessive
for the amount of product being applied. Reduce the air pressure in the gun in order to ensure that
the solvent in the paint does not evaporate during spraying and that this is not dry when it reaches the
surface to be painted. Increase the amount of product, correct its viscosity or use a larger fluid
tip in the gun.
If the film is thick, this is due to the fact that the air pressure is excessive for the amount of product to
be applied. Decrease the amount of product, reduce its viscosity or use a smaller fluid tip in the gun.
If sagging occurs, this is due to the fact that the amount
of product to be applied is excessive for the air pressure
used, that the viscosity is not correct or the application
speed is not adequate. Decrease the amount of
product, adjust its viscosity or increase the
application speed until the required finish is obtained.
The spraying width (spraying pattern) obtained will
depend on the air nozzle used. If nozzles are required
for other applications, contact the Technical Service
of SAGOLA S.A.U.
Apply the product perpendicularly to the part.
07.2.- Tips for application in different climatic zones
Paint application, especially waterbone paints.
Temperature
50
40
30
20
10
www.sagola.com
(
o
C)
Do not apply paint in these conditions
10
20
30
40
50
an Elcometer company
60
70
80
90 100
RH (%)
EN
25
Publicité
