Elcometer Sagola MINI XTREME MIX Manuel D'utilisation page 27

1.- Prepare the paint (blend and filter the paint to the appropriate viscosity - refer to the material
technical data).
2.- When assembling the equipment, make sure to connect
the air hose to the air inlet must be (clean dry air, maximum
air pressure = 2 bar / 29 psi) (No.1) and the product hose to
the product conduits (No.2).
3.- Prime the pump (refer to pump instruction manual).
4.- Select a spray nozzle refer to TIPS nozzle chart and
spring (yellow spring 120 bar / 1,740 psi or red spring 200 bar
/ 2,900 psi).
5.- Make sure white seal or micro-filter is in place in the spray
nozzle. (Optional)
6.- Install the spray nozzle inside the air cap being certain
the locating pins is aligned with mating recesses of the nozzle.
7.- Unlock the security system. To do this, loosen up to the
stop (No.3) (counter-clockwise).
8.- Insert the air cap with its nozzle into the retaining ring. Screw retaining ring and air cap firmly onto
the spray gun positioning the air cap to obtain the desired pattern orientation.
9.- Point the gun into a waste container and and open the gun by using the trigger until clean material
flows.
10.- Adjust the pump air pressure (red regulator) for the desired flow rate.
11.- Adjust spraying air pressure (grey regulator) until the pattern is even.
The drawing shows the relation between fan pattern and spraying
air pressure.
Don't increase spraying air pressure once the correct
fan is obtained. It would lead to more spraying mist.
12.- Optimize fan width (No.3) by means of the air
adjusting knob located at the rear part of the gun.
Regulator
closed
Narrow fan or round fan
Regulator open
If more material or less material is required, select another Tip (refer
to Mixed TIPS spray nozzle chart).
www.sagola.com
Large fan
an Elcometer company
No Not
air enough air
Narrow
Large fan fan or
round fan
3
1
2
Spraying air
correct
EN 27