Toro Recycler 55cm Manuel De L'opérateur page 8

Recycling the Clippings
Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before recycling the clippings.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
recycling the clippings.
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
(refer to Removing the Side Discharge Chute) before
bagging the clippings.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 13).
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the
bag rest in the notches on the handle (Figure 13).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
8
Figure 13
3. Grass bag pin (2)