Toro Recycler 55cm Manuel De L'opérateur page 12

4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 18). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Replacing the Blade
Service Interval: Yearly
Important: You will need a torque wrench to install
the blade properly . If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If
the blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened and
balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance.
2. Tip the mower onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
(Figure 20).
Figure 19
4. Remove the blade, saving all mounting hardware
(Figure 20).
5. Install the new blade and all mounting hardware
(Figure 21).
Important: Position the curved ends of the
blade to point toward the mower housing.
6. Use a torque wrench to tighten the blade bolt to
60 ft-lb (82 N-m).
Important: A bolt torqued to 60 ft-lb (82 N-m)
is very tight. While holding the blade with a
block of wood, put your weight behind the
12
Figure 20
Figure 21