Toro Recycler 55cm Manuel De L'opérateur page 3

speed on slopes and in sharp turns to prevent
overturning or loss of control.
• Stop the blade if the lawn mower has to be tilted for
transportation when crossing surfaces other than
grass and when transporting the lawn mower to and
from the area to be mowed.
• Do not operate the engine in a confined space where
dangerous carbon monoxide fumes can collect.
• Stop the engine
– whenever you leave the lawn mower.
– before refueling.
– before removing the grass catcher.
– before making height adjustment unless
adjustment can be made from the operator's
position.
• Stop the engine and disconnect the spark-plug wire.
– before clearing blockages or unclogging chute.
– before checking, cleaning or working on the lawn
mower.
– after striking a foreign object, inspect the lawn
mower for damage and make repairs before
restarting and operating the lawn mower.
– if lawn mower starts to vibrate abnormally (check
immediately).
• Lightning can cause severe injury or death. If you see
lightning or hear thunder in the area, do not operate
the machine; seek shelter.
• Watch out for traffic when crossing or near roadways.
Maintenance and Storage
• Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
• Do not use pressure cleaning equipment on machine.
• Never store the equipment with gasoline in the tank
and inside a building where fumes can reach an open
flame or spark.
• Allow the engine to cool before storing in any
enclosure.
• To reduce the fire hazard, keep the engine, silencer,
battery compartment and gasoline storage area free
of grass, leaves, or excessive grease.
• Check grass catcher components and the discharge
guard frequently and replace with manufacturer's
recommended parts, when necessary.
• Replace worn or damaged parts for safety.
• Replace faulty silencers.
• If the fuel tank has to be drained, do this out-doors.
• Do not change the engine governor settings or
overspeed the engine. Operating an engine at
excessive speed can increase the hazard of personal
injury.
• On multibladed lawn mowers, take care as rotating
one blade may cause others to rotate.
• Be careful during adjustment of the lawn mower to
prevent entrapment of the fingers between moving
blades and fixed parts of the lawn mower.
• To ensure the best performance and safety,
purchase only genuine Toro replacement parts
and accessories. Do not use will fit parts and
accessories; they may cause a safety hazard.
Sound Pressure
This unit has a sound pressure level at the operator's
ear of 89 dBA, which includes an Uncertainty Value (K)
of 1 dBA. The sound pressure level was determined
according to the procedures outlined in EN 836.
Sound Power
This unit has a guaranteed sound power level of 98 dBA,
which includes an Uncertainty Value (K) of 1 dBA. The
sound power level was determined according to the
procedures outlined in ISO 11094.
Vibration
This unit does not exceed hand/arm vibration levels of
5.5 m/s 2 for the left hand and 5.4 m/s
hand, each including an Uncertainty Value (K) of 2.2
2
m/s . The measured values were determined according
to the procedures outlined in EN 836.
Safety and Instructional
Decals
Important: Safety and instruction decals are
located near areas of potential danger. Replace
damaged decals.
Manufacturer's Mark
1. Indicates the blade is identified as a part from the original
machine manufacturer.
3
2 for the right