EINHELL GE-CM 18/33 Li BL Mode D'emploi page 17

10. Troubleshooting
Problem
Motor does not start
or comes to a stop
(loose connection).
The motor
performance drops.
Cutting is irregular.
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period.
Anl_GE_CM_18_33_Li_BL_SPK7_NA.indb 17 Anl_GE_CM_18_33_Li_BL_SPK7_NA.indb 17
EN
Possible causes
a) The capacitor is defective.
b) The mower is standing in high
grass.
c) The mower housing is clogged.
d) Safety plug is not inserted.
e) Battery is not correctly inserted.
f) The connectors have become
separated from the motor or the
capacitor.
a) The grass is too high or too damp.
b) The mower housing is clogged.
c) The blade is severely worn.
d) Battery performance
decreasing.
a) The blade is worn.
b) Wrong cutting height.
- 17 -
Solution
a) Have repaired by service center.
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary.
c) Clean the housing so that the blade
moves freely.
d) Insert safety plug (see 6).
e) Remove the battery and reinsert
(see 5).
f) Have repaired by service center.
a) Correct the cutting height.
b) Clean the housing.
c) Replace the blade.
d) Check the battery performance
and charge the battery if necessary
(see 5).
a) Replace or resharpen the blade.
b) Correct the cutting height.
15.11.2023 09:25:41 15.11.2023 09:25:41