Télécharger Imprimer la page

ZANKER KBT23001SB Notice D'utilisation page 19

Masquer les pouces Voir aussi pour KBT23001SB:

Publicité

Les langues disponibles

Les langues disponibles

Problem
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, contact the nearest Authorised
Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the illustration).
Installation
Warning! Refer to Safety chapters.
Location
Refer to the assembly instructions for the
installation.
To ensure best performance, install the appliance well
away from sources of heat such as radiators, boilers,
Possible cause
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
3. Replace the used lamp with a new lamp of the
same power and specifically designed for
household appliances (the maximum power is
shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
direct sunlight etc. Make sure that air can circulate
freely around the back of the cabinet.
Positioning
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Solution
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature de-
crease to room temperature before
storage.
Store less food products at the same
time.
Defrost the appliance.
Open the door only if necessary.
19

Publicité

loading