Télécharger Imprimer la page

ZANKER KBT23001SB Notice D'utilisation page 18

Masquer les pouces Voir aussi pour KBT23001SB:

Publicité

Les langues disponibles

Les langues disponibles

Warning! If you want to keep the
appliance switched on, ask somebody to
check it once in a while to prevent the
food inside from spoiling in case of a
power failure.
Troubleshooting
Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The lamp does not work.
The compressor operates continual-
ly.
Water flows inside the refrigerator.
18
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
Solution
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket. Contact a quali-
fied electrician.
Check if the appliance stands stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation".
Wait some hours and then check the
temperature again.
Refer to climate class chart on the rat-
ing plate.
Allow food products to cool to room
temperature before storing.
Position the water drainage plug in the
correct way.
Wrap the food products better.
Refer to "Operation" .
Clean the water outlet.
Make sure that food products do not
touch the rear plate.

Publicité

loading