Electrolux EOC6631 Notice D'utilisation page 32

32 www.electrolux.com
3. Close the oven door halfway to the
first opening position. Then pull
forward and remove the door from its
seat.
4. Put the door on a soft cloth on a
stable surface.
5. Release the locking system to remove
the glass panels.
6. Turn the two fasteners by 90° and
remove them from their seats.
7. First lift carefully and then remove the
glass panels one by one. Start from
the top panel.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct sequence.
The middle panel (B) has a decorative
frame. The screen-printing zone must face
the inner side of the door. Make sure that
after the installation the surface of the
glass panel frame (B) on the screen-
printing zones is not rough when you
touch it.
90°
2
1