Eurosystems TR 80 Manuel D'utilisation Et D'entretien page 42

DANGER!
Replace damaged guards before using
the machine!
6.3. CLEANING AND WASHING
Clean and wash the accessory/tool after
each use.
Cleaning:
It is possible to clean the accessory/tool
using compressed air.
ATTENTION!
Under no circumstances the protection
covers can be removed from the ma-
chine.
Washing:
Carefully wash the contact surfaces
between the guides and blade sections
DANGER!
Do not use pressurised water to wash
the accessory/tool when connected
or in close proximity to the machine.
Pressure can damage the electrical
system. Avoid excessive use of water
or the use of water near sensitive parts
such as the motor, batteries, labels, and
electrical systems.
EN-14
6.4. GREASING
[ fig. 11]
Every 25÷30 working hours , grease the
oscillating pin using the greaser (1) placed
under the front protection cover
Every 25÷30 working hours , grease the
screw bushings which are adjusting the
cutting height of the wheels [2].
6.5. CHANGE , ADJUSTMENT AND
BALANCING OF THE CUTTING BLADES
Every 130÷150 working hours at the best
conditions, change the blades applying to
a service center or to an authorized dealer
eurosystems.
Every 400÷450 working hours at the best
conditions, check the balancing shaft
blades, please apply to a service center
or an authorized eurosystems dealer.
7. STORAGE
ATTENTION!
Park the accessory/tool (with or without
the connected machine) on stable
ground.
Short or long term storage:
1. Clean the accessory properly;
2. Cover the accessory/tool with a
nylon or fabric cover;
[4, fig. 01]